583
Chapter 24, Connector, Key, and Knob Descriptions
Key Descriptions
Miscellaneous Keys and Buttons
• [SHIFT] is used to select the blue-labeled functions listed above some keys (such as
PRINT, CONFIG, RELEASE, EEX and so forth).
• [CANCEL] is used to cancel an entry in progress, or to stop a running IBASIC program.
For example, if you press [RECALL] to recall an instrument setup, and then decide not
to recall a setting, pressing [CANCEL] exits the recall procedure.
• Left-arrow key (backspace) is used to move the cursor to the left when entering num-
bers in a field, such as RF Gen Freq. Each press of this key moves the cursor one
place to the left, erasing the previous character.
• The rear-panel AC/DC button setting selects the instrument’s power source. The power
source must be changed with the Test Set turned off.
• [POWER] turns the instrument power on and off. Several CONFIGURE screen set-
tings, and all SAVE/RECALL registers, are retained by battery back-up when power is
disconnected.
USER Keys
These keys are used to instantly access fields without using the cursor-control
knob or changing screens.
See Also
"Using USER Keys" on page 80.
To Next Page
Loading...
