135
Chapter 6, Call Processing Subsystem
The CALL CONTROL Screen
[] Page
When lit, the Page annunciator indicates that the mobile station connected to the
Test Set is currently being paged on the forward control channel.
Phone Num:
This field displays the decoded MIN number received from the mobile station on
the reverse control channel in response to a forward control channel message. The
Phone Num: field is displayed only when the Display field is set to Data and a
reverse control channel message containing this information has been decoded.
CAUTION: Do not confuse the Phone Num: field, which is displayed in the upper right-hand portion of
the CALL CONTROL screen, with the Phone Num selection of the MS Id field.
NOTE: An all zero MIN number (000000000), which does not represent a valid phone number, will
convert to the following phone number: 111111?111.
Register
This field is used to initiate a registration of the mobile station that is connected to
the Test Set. The Test Set must be in the active state (that is, the
Active
annunciator must be lit) before you can attempt to register the mobile station.
[] Register
When lit, the Register annunciator indicates that the mobile station connected
to the Test Set is being commanded to register with the Test Set.
Release
This field is used to terminate an active voice channel connection with the mobile
station. When the
Release field is selected, a mobile station control message
with a release order is sent to the mobile station on the forward voice channel. A
mobile station must be actively connected on a voice channel to the Test Set (that
is, the
Connect annunciator must be lit) before you can attempt to send a release
order to the mobile station.
To Next Page
Loading...
