HP 8920A - Page a Mobile Station with Authentication; Paging a Mobile Station that Has Registered with the Test Set

156
S:\HP892XX\USRGUIDE\manual\callscrn.fb
Chapter 6, Call Processing Subsystem
Using the CALL CONTROL Screen to test AMPS Authentication
Page a Mobile Station with Authentication
Paging A Mobile Station That Has Registered With The Test Set
1. Ensure that the Test Set is in the active state. See "Turn on the Test Set’s Control
Channel" on page 154 for information on how to activate the Test Set.
2. Connect the mobile station to the Test Set as shown in Figure 17, "Connecting a
Mobile Station to the Test Set," on page 119.
3. Turn on the mobile station.
4. If the CALL CONTROL screen is not displayed, select CALL CNTL from the To
Screen menu. The CALL CONTROL screen will be displayed.
5. Position the cursor on the Display field and select Data.
6. Ensure that the mobile station has registered with the Test Set. See "Initialize Call
Processing with Authentication" on page 154 for information on how to register the
mobile station.
7. Select the Page field. The Page annunciator will light while the Test Set pages the
mobile on the forward control channel. If the mobile station responds properly on the
reverse control-channel the message RECC Return will flash momentarily in the
upper right-hand corner of the CALL CONTROL screen. The Access annunciator
will then light while the Test Set sends the mobile station an alert order on the assigned
voice channel. The mobile station should ring.
8. Press the SEND key on the mobile station. The Connect annunciator will light if the
mobile station properly signals the Test Set. The mobile station is now connected to the
Test Set on the assigned voice channel. The Voice Channel Assignment fields
will be updated, that is, any “-” in the left-hand fields will be replaced with appropriate
information. If page with authentication was successful, “Page w/Auth
successful” will be displayed in the upper right-hand portion of the CALL
CONTROL screen. If page with authentication failed, then “Page w/Auth
failed” will be displayed in the upper right-hand portion of the CAll CONTROL
Screen.