263
Chapter 7, Configure Screen
Field Descriptions
RF Display
This field selects the format for entering the RF Generator’s and RF Analyzer’s
frequencies:
•When Freq is selected, you enter the RF Generator’s and the RF Analyzer’s
frequencies directly using the keypad or knob.
•When Chan is selected, the RF Gen Freq and Tune Freq fields on all screens are
replaced by the RF Channel field, and only the channel number is entered and
displayed.
Channel tuning eliminates the need to enter transmit and receive frequencies
directly into the Test Set. Once your radio’s RF channel standard is selected, you
only have to enter the channel number to automatically set the RF Generator and
RF Analyzer to the correct frequencies.
Operating Considerations
When channel tuning is used, the RF Analyzer is set to manual tuning. The Tune
Mode
field on the TX TEST, DUPLEX TEST, and RF ANALYZER screens is no
longer displayed. As a result, the
TX Freq Error measurement is displayed
(since the
TX Frequency measurement is only displayed when the Tune Mode
field is set to
Auto).
See Also
RF Chan Std
field description, on page 262
To Next Page
Loading...
