HP 8920A - DATA FUNCTIONS Keys

581
Chapter 24, Connector, Key, and Knob Descriptions
Key Descriptions
DATA FUNCTIONS Keys
[INCR ³10], [INCR SET], and [INCR ×10] are used to change the increment or decrement
a value when changing field values.
• Up-arrow and down-arrow keys increment or decrement field values. These keys are
also used to select alternate field entries without displaying the Choices menu used
by some fields. They are also used to move the cursor in string entry fields (such as the
Print Title field on the PRINT CONFIGURE screen).
• LO LIMIT ([SHIFT], down-arrow key) and HI LIMIT ([SHIFT], up-arrow key) and set
measurement end points. Exceeding the end points causes screen prompts to blink until
they are reset.
REF SET ([SHIFT], [INCR ³10]) is used to enter or remove a measurement reference for
relative AF and RF measurements.
METER ([SHIFT], [INCR SET]) enables or disables the analog bar-graph meter function
for measurements using large digits (such as the RX TEST and TX TEST screen measure-
ments).
AVG ([SHIFT], [INCR ×10]) enables or disables measurement averaging.
See Also
"Operating Overview" on page 53.