320
S:\HP892XX\USRGUIDE\manual\decoscrn.fb
Chapter 8, Signaling Decoder Screen
NMT Decoder
Run Test
Selecting this function executes (runs) the NMT test specified in the Load Test
field or entered directly into the
NMT Test Entry field.
Single/Cont
This field specifies how you want the test to be run:
• Single executes the NMT program and displays the decoded information once each
time Run Test is selected.
• Cont continually re-runs the program, and displays the decoded information, until
Single is selected.
Stop Test
Selecting this field interrupts the NMT test while running. If Cont is selected, the
program automatically re-runs from the beginning.
Standard
This field specifies the NMT standard for the signal being decoded.
Operating Considerations
This setting alters the decoder’s function by specifying the expected frame
structure and channel range for the incoming signal.
Trying to run a test with the wrong standard selected will result in incorrect
decoded data, or will display an operating error message.
See Also
Trig Level
field description, on page 275
"Standard Equivalents" on page 323
Trig Level
Trigger level indicates the minimum signal level required to begin a
measurement. This level is adjusted by changing the
Input Level field setting.
To Next Page
Loading...
