265
Chapter 7, Configure Screen
Field Descriptions
RF Level Offset
This field enables/disables the RF level offsets entered in the RF In/Out,
Duplex Out, and Antenna In fields below it.
• When set to On, the RF Generator’s amplitude and RF Analyzer’s power measurement
are offset by the values entered in these fields.
• When set to Off, the values in these fields are ignored.
See Also
Antenna In
field description, on page 255
Duplex Out
field description, on page 258
RF Chan Std
field description, on page 262
RF Offset
This field is displayed when the RF Display field has Freq selected.
This field enables/disables the RF Generator
−RF Analyzer frequency offset
specified in the
(Gen)-(Anl) field below it.
Operating Considerations
When an RF offset is used, changing the RF Generator’s frequency or RF
Analyzer’s tune frequency automatically alters the other setting. On screens
where both fields are not shown (such as the RX TEST and TX TEST screens),
you will not see the corresponding field change.
See Also
"Setting an RF Generator/Analyzer Offset" on page 84
To Next Page
Loading...
