390
S:\HP892XX\USRGUIDE\manual\encoscrn.fb
Chapter 10, Signaling Encoder (AF Generator 2)
Using the EDACS Encoder
Mobile Receiver Test Procedure
The following procedure establishes a control channel connection between the
Test Set and your mobile, and then performs a handshake to pass the mobile to a
working channel. Receiver measurements can then be made.
NOTE: Each EDACS radio is pre-programmed to access a specific control channel and one or more
working channels. Other identification information is also
pre-programmed into the mobile (such as the Logical ID and Group ID numbers). You cannot
test an EDACS mobile without entering these values into the Encoder.
Connect the Mobile to the Test Set
1. Press the PRESET key on the Test Set.
2. Connect the mobile’s antenna port to the Test Set’s RF IN/OUT port.
3. Connect the mobile’s audio output to the AUDIO IN HI port of the Test Set. (The AU-
DIO IN LO port is typically only used when the mobile’s antenna port shield is not at
the same potential as the audio output shield. See the AF ANALYZER screen, Audio
In Lo field description, on page 103.)
4. Turn the mobile on.
To Next Page
Loading...
