257
Chapter 7, Configure Screen
Field Descriptions
Beeper
This field changes the audio beeper volume by selecting the desired level from a
list of choices. The beeper always beeps when the instrument is turned on,
regardless of this setting.
Operating Considerations
The beeper alerts you any time a message is displayed. Since a message may be
removed from the screen before you notice it, it is better to leave the beeper on to
alert you to errors during operation.
The beeper’s volume setting is retained when the instrument is turned off.
Chan Space
(User Defined)
This field specifies the RF channel spacing when the RF Display field is set to
Chan, and the RF Chan Std field is set to USER-DEF.
For example, entering
25 kHz causes a 25 kHz spacing between each channel. If
the receive frequency for channel 1 is 150.500 MHz, channel 2’s receive
frequency would be 150.525 MHz.
Operating Considerations
The value of this field is only used if the RF Display field is set to Chan, and the
RF Chan Std field is set to USER-DEF.
See Also
(Gen)-(Anl)
field description, on page 259
RF Chan Std
field description, on page 262
Base Freq (User Defined)
field description, on page 255
To Next Page
Loading...
