124
S:\HP892XX\USRGUIDE\manual\callscrn.fb
Chapter 6, Call Processing Subsystem
The CALL CONTROL Screen
NOTE: The Test Set may still be outputting a modulated RF carrier but the Test Set’s firmware is not
active and no communication can occur between a mobile station and the Test Set.
AF Freq
The AF Freq field is displayed only when the Display field is set to Meas.
This field displays the audio frequency of the demodulated FM signal being
transmitted by the mobile station. Four dashes (----) indicate that no audio
frequency is present to measure. A numeric value would only be displayed when
the Test Set’s
Connected annunciator is lit (connected state).
Amplitude
This field is used to set the output power of the Test Set’s transmitter (that is, the
output power of the Test Set’s RF Generator).
Called Number:
This field displays the called phone number, in decimal form, received from the
mobile station on the reverse control channel when the mobile station originates a
call. The
Called Number: field is displayed only when the Display field is set
to
Data and a reverse control channel message has been decoded when the mobile
originates a call.
To Next Page
Loading...
