HP 8920A - Unit-Of-Measure Field; Underlined Immediate-Action Field; To Change an Underlined Entry; To Change a Unit-Of-Measure

44
S:\HP892XX\USRGUIDE\manual\getstart.fb
Chapter 1, Get Started
Changing A Field’s Setting
Unit-of-Measure Field
Unit-of-measure can be changed to display measurements in different values or
magnitudes. See item 1 in
figure 3 to see an example of a units-of-measure field.
To change a unit-of-measure
1. Position the cursor at the unit field on the display.
2. Press a key labeled with a different unit-of-measure (such as W).
If the new units are valid, the measurement value is displayed in the unit.
Underlined Immediate-Action Field
Underlined immediate action fields provide a choice of two settings. See item 2 in
figure 3 to see an example of an underlined immediate-action field.
To change an underlined entry
1. Position the cursor at the field.
2. Push the CURSOR CONTROL knob or the ENTER key to move the underline under
the desired choice.
The underlined setting is immediately activated when selected.