HP 8920A - Oscilloscope Main Functions; Oscilloscope Main Menu Fields

447
Chapter 14, Oscilloscope Screen
Field Descriptions
Oscilloscope Main Menu Fields
Figure 111 Oscilloscope Main Functions
Time/div
This field selects the horizontal sweep time per division.
Operating Considerations
The time-per-division is selected from a list of choices.
Vert Offset
Vertical offset moves the displayed signal above or below the oscilloscope’s fixed
centerline.
Operating Considerations
A centerline is displayed for the signal when an offset is used.
When the vertical offset is
≠0.00, the marker level is referenced to the center line
generated by the vertical offset feature, not the center line of the screen.
Vert/div
Vertical sensitivity sets the vertical amplitude per division.
Operating Considerations
The value for this field is selected from a list of choices.
Depending on the AF Analyzer’s
AF Anl In setting, the units for this field may
be in Volts, kHz, or Percent (AM). For example; if the
AF Anl In field is set to
FM Demod, the amplitude is displayed in kHz/div.
oscscrn3.wmf