131
Chapter 6, Call Processing Subsystem
The CALL CONTROL Screen
DSAT/DST (hex)
The DSAT/DST field is displayed only when the System Type field is set to
NAMPS and Display field is set to NMeas.
The
DSAT/DST field displays the received DSAT/DST sequence from the mobile
station on the reverse voice channel. The received sequence is displayed in
hexadecimal form and can be checked against the DSAT value displayed in the
DSAT right-hand DSAT field. Four dashes (----) indicate no carrier is present to
measure. A hexadecimal value would only be displayed when the Test Set’s
Connected annunciator is lit (connected state).
ESN (dec):
This field displays the electronic serial number (ESN), in decimal form, received
from the mobile station on the reverse control channel in response to a forward
control channel message. The
ESN (dec): field is displayed only when the
Display field is set to Data and a reverse control channel message containing
this information has been decoded.
ESN (hex):
This field displays the electronic serial number (ESN), in hexadecimal form,
received from the mobile station on the reverse control channel in response to a
forward control channel message. The
ESN (hex): field is displayed only when
the
Display field is set to Data and a reverse control channel message
containing this information has been decoded.
FM Deviation
This field displays the measured FM deviation of the RF carrier being transmitted
by the mobile station on the reverse voice channel. Four dashes (----) indicate no
carrier is present to measure. A numeric value would only be displayed when the
Test Set’s
Connected annunciator is lit (connected state). The FM Deviation
field is only displayed when the
Display field is set to Meas.
To Next Page
Loading...
