76
S:\HP892XX\USRGUIDE\manual\opoverv.fb
Chapter 3, Operating Overview
Saving and Recalling Instrument Setups
Saving and Recalling Instrument Setups
The SAVE and RECALL functions allow you to store different instrument setups
and retrieve them later, eliminating the task of re-configuring the Test Set.
The number of available save registers depends on how many changes were made
to the base instrument setup for each save. (See
"BASE Settings" on page 79.) The
smaller the number of changes, the greater the number of save registers that can
be used (typically over 200).
Save/Recall register settings can be saved to several types of mass storage. This
allows you to “back up the settings in case you need to clear them from memory
(see
"Memory Considerations" on page 79) for running large programs, or when a
firmware upgrade is performed (see
"Save/Recall" on page 441).
To Save an Instrument Setup
Use the More menu to access the I/O CONFIGURE screen. )
1. Select the storage media using the Save/Recall field. (The default is internal mem-
ory.
2. Make any changes to the instrument that you want to save in a register.
3. Press and release the SHIFT key then the RECALL key to access the SAVE function.
4. Use the DATA keys or the Save menu at the bottom right of the screen to enter the
register’s name.
To Recall an Instrument Setup
Use the More menu to access the I/O CONFIGURE screen.
1. Select the media to recall settings from using the Save/Recall field. The default is
internal memory.
2. Press RECALL.
3. Use the knob to select the desired setup to be recalled from the Recall menu at the
bottom-right of the screen.
To Next Page
Loading...
