144
S:\HP892XX\USRGUIDE\manual\callscrn.fb
Chapter 6, Call Processing Subsystem
Using the CALL CONTROL Screen to Test Call Processing Functions
Register a Mobile Station
Ensure that the Test Set is in the active state. See "Turn On The Test Set’s Control
Channel" on page 143 for information on how to activate the Test Set.
1. Connect the mobile station to the Test Set as shown in Figure 17, "Connecting a Mo-
bile Station to the Test Set," on page 119.
2. Turn on the mobile station.
3. If the CALL CONTROL screen is not displayed, select CALL CNTL from the To
Screen menu. The CALL CONTROL screen will be displayed.
4. Position the cursor on the Display field and select Data.
5. Select the Register field. The Register annunciator will light while the
registration is in process. If the mobile station responds properly on the reverse control
channel, the message RECC Return will flash momentarily in the upper right-hand
corner of the CALL CONTROL screen and the mobile station phone number, ESN and
decoded SCM will be displayed in the upper right-hand portion of the CALL
CONTROL screen. The information in the MS Id field will be updated. The Active
annunciator will light when the registration has successfully completed.
To Next Page
Loading...
