376
S:\HP892XX\USRGUIDE\manual\encoscrn.fb
Chapter 10, Signaling Encoder (AF Generator 2)
Digital Paging Encoder
Pager Alpha-Numeric Message
This field specifies the message you are sending to an alpha-numeric format
pager.
This field is only displayed when the
Pager Type is set to Numeric or
Alpha-Num.
Pager Code
This field is used to identify the individual code number (address) of the pager
you are testing.
Pager Numeric Message
This field specifies the message you are sending to a numeric format pager.
This field is only displayed when the
Pager Type is set to Numeric or
Alpha-Num.
Pager Type
This field specifies the way your pager responds to a received signal:
Tone-Only (beeps), Numeric (displays numbers), or Alpha-Numeric (displays
numbers and other characters).
Polarity
This setting determines the relationship between the data stream’s logic levels and
the effect on the modulated signal.
Normal Operation. When this field is set to
Norm, a logical high (1) causes the
output level of the AF Generator to be more positive (causing a positive frequency
deviation when FM is used). A logical low (0) causes the level to become negative
by the same amount (resulting in negative FM deviation).
Inverted Operation. When this field is set to
Invert, a logical high (1) causes
the output level of the AF Generator to be more negative (causing a negative FM
deviation). A logical low (0) causes the level to become positive by the same
amount (resulting in positive FM deviation).
To Next Page
Loading...
