HP 8920A - Page 168

168
S:\HP892XX\USRGUIDE\manual\callscrn.fb
Chapter 6, Call Processing Subsystem
CALL DATA Screen
Handoff
This field is used to initiate a handoff from the current voice channel assignments
to a new set of voice channel assignments. The voice channel number to hand the
mobile station off to, the channel location (NAMPS system type only), the initial
power level to use on the new voice channel, the DSAT sequence (NAMPS
system type only) to transpond on the mobile station, and the SAT tone frequency
to transpond on the new voice channel are specified using the
Chan:, Ch Loc:,
Pwr Lvl:, DSAT:, and SAT: fields in the Voice Channel Assignment
section of the CALL CONTROL screen.
This field is used to initiate a handoff from the current voice channel assignments
to a new set of voice channel assignments. The voice channel number to hand the
mobile station off to, the initial power level to use on the new voice channel, and
the SAT tone frequency to transpond on the new voice channel are specified using
the
Chan:, Pwr Lvl:, and SAT: fields in the Voice Channel Assignment
section of the CALL CONTROL screen.
Order
This field is used to send an order on the forward voice channel to the mobile
station. The orders available are:
• Change Power to Power Level 0 - 7
• MRI (issues a request for mobile reported interference report, NAMPS system type
only)
Maintenance (puts the mobile station in maintenance mode)
• Alert (alerts the mobile station)
The Order field is a one-of-many selection field. To send an order to the mobile
station select the
Order field. A list of choices is displayed. Select the desired
order from the
Choices: menu. Once the selection is made, a mobile station
control message is sent to the mobile station. The
Access annunciator will light
momentarily while the Test Set is sending the mobile station control message.
A mobile station must be actively connected on a voice channel to the Test Set
(that is, the
Connect annunciator must be lit) before you can attempt to send an
order to a mobile station.
When the Authent is set to ON, the Order field is not displayed.