261
Chapter 7, Configure Screen
Field Descriptions
The following fields are affected by the Range Hold field:
• RX/TX Cntl in the CONFIGURE screen.
• Tune Mode in the TX TEST, DUPLEX TEST, and RF ANALYZER screens.
• Input Atten in the RF ANALYZER and SPECTRUM ANALYZER screens.
• Gain Cntl in the AF ANALYZER screen. This field controls three AF gain setting
fields:
Input Gain
De-Emp Gain
Notch Gain
Operating Considerations
The Hold All setting is primarily used when the instrument is operated by
remote control, such as in an automated test system.
Unless you have very specific reasons for disabling the automatic functions, you
should set this field to
Auto All when operating the instrument manually.
See Also
Programmer’s Guide
To Next Page
Loading...
