303
Chapter 8, Signaling Decoder Screen
Function Generator Decoder
Stop Meas
Selecting this field stops the analyzer when making single measurements.
Single/Cont
This field specifies how you want the analyzer to be armed:
• Single is used to analyze and display the decoded information once each time
Arm Meas is selected.
• Cont is used to automatically re-arm the analyzer and display the measurements on a
continual basis until Single is selected.
Trig Level
The trigger level indicates the minimum signal level required to begin a
measurement that has been “armed”. The level is adjusted by changing the
Input Level field setting.
To Next Page
Loading...
