308
S:\HP892XX\USRGUIDE\manual\decoscrn.fb
Chapter 8, Signaling Decoder Screen
LTR Decoder
Single/Cont
This field specifies how long you want the analyzer to decode incoming signals:
• Single tells the analyzer to display valid LTR information received during one gate
time.
• Cont is used to automatically re-arm the analyzer and display the measurements on a
continual basis until Single is selected.
Stop Meas
Selecting this field stops the analyzer when making single measurements.
Trig Level
The trigger level indicates the minimum signal level required to begin a
measurement that has been “armed.” The level is adjusted by changing the
Input Level field setting.
To Next Page
Loading...
