HP 8920A - Page 366

366
S:\HP892XX\USRGUIDE\manual\encoscrn.fb
Chapter 10, Signaling Encoder (AF Generator 2)
AMPS-TACS NAMPS-NTACS Encoder
Send Mode
This field selects the mode used when Send is selected to output the message.
• Single outputs the entire message once.
• Burst outputs the Message the number of times specified in the Bursts field.
• Cont causes the message to be output continuously until Stop is selected.
• Step is not used in the AMPS-TACS mode.
Standard
This field selects the signaling standard used for your radio. The standard values
used for each signaling format are automatically filled-in when the standard is
selected.
Stop
Selecting this field stops the message being output.
Stop DSAT (FVC)
This field is available only in NAMP-NTAC mode.
Selecting this field stops the digital supervisory audio tone being output.
Stop Filler (FOCC)
Selecting this field stops the Filler information from being output after
Send Filler or Send is used.