Chapter 5: Console Operation
Smart Faders (SFADs): Master SVCA Parameters
154/ 526 2.0 Eclipse User Guide
Master SVCA Parameters
Now move back to your Smart VCA master channel (e.g. drum)
and note that you have master control over the following
parameters:
1. Move the SVCA fader to adjust the overall level of the
Smart Fader slaves.
Just like normal VCAs, Smart VCAs use non-moving faders so
you will not see the slave faders move in the SZONE.
2. Press MUTE on the SVCA Fader strip to mute or
unmute the slave channels.
Note that the SVCA MUTE will not override any existing slave
channel MUTEs. This is indicated on the slave channels as
follows:
• MUTE flashing – the channel is muted only by the VCA.
When you unmute the VCA, the channel MUTE cancels.
• MUTE steady state - the channel MUTE is active; it will
not be affected by the VCA MUTE. To unmute the
channel you must unmute both the VCA and the slave.
3. Press CUE on the SVCA Fader strip to activate CUE on
all the slave channels.
Note that you can deselect individual CUE buttons from the
SZONE slaves if you wish. If you do this, then you will need to
deselect all slave CUEs before you can re-activate them from
the SVCA master.
To Next Page
Loading...
