Chapter 5: Console Operation
Mix Busses: Bus Routing
Eclipse User Guide 2.0 161/ 526
Panning to Stereo Busses
When a route is made to a stereo mix bus, the channel is
assigned to all component busses ā Left, Right and Centre (if
applicable) ā and the main channel pan position is applied.
For Auxes and Groups, you can set the mix bus send to be
independent of the main channel pan. See Page 126. This
allows you to pan to Auxes and Groups with separate pan
positions for each mix bus.
When you route stereo or LRC busses to each other, then
component channels are routed one-to-one, panning is applied
(from Auxes and Groups only) or summed, as shown below:
Note that panning can only be applied on Aux or Group output
channels. You cannot pan a Matrix or Master.
To Next Page
Loading...
