Chapter 6: Console Configuration
The Patch Output Display
254/ 526 2.0 Eclipse User Guide
Controlling Output Parameters
At the bottom of the display, the Output Adj controls adjust and
meter the selected destination:
• Output Gain – left-click to increase or right-click to
decrease the gain. Or press [F5] or [F6].
This adjusts the output level on the card 0.5dB steps. It
corresponds to the output level, in dBu, received when a signal
at 0dBFS, measured on the vu meter of the desk, is routed to
the output.
• MUTE – left-click to mute or unmute the output. Or press
[F8].
When muted, a red LED appears beside the output Label:
To Next Page
Loading...
