Chapter 3: Operating Principles
Routing, Sends and the SEL Button
78/ 526 2.0 Eclipse User Guide
Multiple Assign Short Cut
This short cut method can be used to route multiple channels to
a mix bus in one operation.
Let’s take an example of Reverse Bus Assign where we want to
route 8 input channels (Faders 17 to 24) onto the Master:
1. Press SEL on the Master channel (with a red ID).
The SEL button and Label on the Master should be flashing.
2. Press and hold the flashing SEL button on the Master.
3. Then press and hold SEL on the first input fader:
4. Release the Master SEL button (but keep holding the
input SEL), and press SEL on the last input fader:
5. Release both SEL buttons.
All channels between your first and last selections are assigned
to the Master:
Note that you can only make multiple assignments in this way if
all the channels you wish to select begin in the same state –
either all on (SEL lit) or all off (SEL unlit).
To Next Page
Loading...
