Table 107: show mpls interface and show mpls l2transport interface
Output Fields (continued)
Field DescriptionField Name
Maximum number of ATM cells that the router can concatenate in
a single packet; if this value is not configured, "ATM cell aggregation:
disabled" appears instead of this field. Displayed for an ATM port
(ATM AAL5 over ATM major interface).
ATM cell aggregation
maximum cells per packet
Identifier (1, 2, or 3) of the ATM Martini cell packing timer that detects
timeout of the cell collection threshold; if this value is not configured,
"ATM cell aggregation: disabled" appears instead of this field.
Displayed for an ATM port (ATM AAL5 over ATM major interface).
ATM cell aggregation
timeout timerID
Administrative state, enabled or disabledAdministrative state
Statement regarding operational state of interfaceOperational state
Maximum transmission unit for the interfaceOperational MTU
Statistics for MPLS traffic received or sent on the interfaceReceived, Sent
Number of packets received or sentpackets
Number of bytes received or sentbytes
Number of packets that are dropped for some reason at receipt or
before being sent
error
Number of packets that are discarded because of lack of buffer
space at receipt or before being sent
discards
MTU specified in received packetsreceived mtu
Queue and traffic class bound to the specified interfacequeue, traffic class, bound
to
Number of bytes in the queueQueue length
Total number of packets and bytes forwarded by this interfaceForwarded packets, bytes
Total number of committed packets and bytes dropped by this
interface
Dropped committed
packets, bytes
Total number of conformed packets and bytes dropped by this
interface
Dropped conformed
packets, bytes
Total number of exceeded packets and bytes dropped by this
interface
Dropped exceeded
packets, bytes
Type (input, output) and name of policyMPLS policy
Copyright © 2010, Juniper Networks, Inc.568
JunosE 11.2.x BGP and MPLS Configuration Guide
To Next Page
Loading...
Need help?
General
