Table 107: show mpls interface and show mpls l2transport interface
Output Fields (continued)
Field DescriptionField Name
Entry indexclassifier-group entry
Number of packets and bytes on the interfacepackets, bytes
Name of profilerate-limit-profile
Number of packets and bytes that conform to the committed access
rate
Committed
Number of packets and bytes that exceed the committed access
rate but conform to the peak access rate
Conformed
Number of packets and bytes that exceed the peak access rateExceeded
VC label sent by this router to upstream neighbor for routeIn label
VC label received by this router from downstream neighbor for routeOut label
MPLS statistics for traffic received or sentMPLS statistics
Number of packets received or sentpkts
Number of high-capacity (64-bit) packets received or senthcPkts
Number of octets received or sentoctets
Number of high-capacity (64-bit) octets received or senthcOctets
Number of packets that are dropped for some reason at receipt or
before being sent
errors
Number of packets that are discarded because of lack of buffer
space at receipt or before being sent
discardPkts
Interface specifierInterface
IP address of the remote PE router or name of the tunnelRemote-PE or LSP-name
VC ID number for the interfaceVirtual Circuit ID
Load-balancing group associated with the layer 2 Martini transport
circuit
Load Balancing Group
Administrative state of the interface, enabled or disabledAdmin state
Operational state of the interface, up or downOper state
569Copyright © 2010, Juniper Networks, Inc.
Chapter 10: Monitoring Layer 2 Services over MPLS
To Next Page
Loading...
Need help?
General
