CHAPTER 8
Installing the PTX5000 Packet Transport
Switch Using a Mechanical Lift
•
Overview of Installing a PTX5000 Packet Transport Switch Using a Mechanical
Lift on page 75
•
Tools Required to Install the PTX5000 Packet Transport Switch Using a Mechanical
Lift on page 76
•
Installing the PTX5000 Packet Transport Switch Using a Mechanical Lift on page 76
Overview of Installing a PTX5000 Packet Transport Switch Using a Mechanical Lift
Before installing the packet transport switch using a mechanical lift, verify that you have
prepared your site, unpacked the packet transport switch from the shipping crate, and
installed the mounting hardware.
Because of the packet transport switch’s size and weight—up to 964 lb (438.2 kg)
depending on the configuration— you must install the packet transport switch using a
mechanical lift.
To install the packet transport switch:
1. Gather the tools required to install the packet transport switch.
See “Tools Required to Install the PTX5000 Packet Transport Switch Using a
Mechanical Lift” on page 76.
2. Read the safety information in “General Safety Guidelines for Juniper Networks Devices”
on page 219 and “PTX5000 Installation Safety Guidelines” on page 225.
3. Install the packet transport switch into the rack using a mechanical lift.
See “Installing the PTX5000 Packet Transport Switch Using a Mechanical Lift” on
page 76.
Related
Documentation
Overview of Preparing the Site for the PTX5000 Packet Transport Switch on page 55•
• Overview of Unpacking the PTX5000 Packet Transport Switch on page 61
• Installing the PTX5000 Mounting Hardware for an Open-Frame Rack on page 71
• Installing the PTX5000 Mounting Hardware for a Four-Post Rack or Cabinet on page 67
75Copyright © 2012, Juniper Networks, Inc.
To Next Page
Loading...
