Figure 72: Removing the PDU
12. Place one hand underneath the PDU to support it and slide it partly out of the chassis
until you can reach the two handles located on each side of the PDU.
13. Use the two handles on each side of the PDU to support it and slide the PDU
completely out of the chassis.
WARNING: Do not touch the power connectors on the rear of the PDU. They
can contain dangerous voltages.
CAUTION: Each PDU weighs approximately 60 lb (27.3 kg). Be prepared to
support the full weight of the PDU as you remove it from the packettransport
switch.
CAUTION: Do not leave a PDU slot empty for more than a short time while
the packet transport switch is operational. For proper airflow, the PDU must
remain in the chassis or a blank panel must be used in an empty slot.
Copyright © 2012, Juniper Networks, Inc.196
PTX5000 Packet Transport Switch Hardware Guide
To Next Page
Loading...
