CHAPTER 11
Providing Power to the PTX5000 Packet
Transport Switch
•
Tools and Parts Required to Provide Power to the PTX5000 Packet Transport
Switch on page 93
•
Connecting DC Power to the PTX5000 Packet Transport Switch on page 94
•
Powering On the DC Powered PTX5000 Packet Transport Switch on page 96
•
Powering Off the PTX5000 Packet Transport Switch on page 98
Tools and Parts Required to Provide Power to the PTX5000 Packet Transport Switch
To connect the packet transport switch to power, you need the following tools and parts:
•
7/16-in. (11 mm) nut driver, with a minimum of 81 lb-in. (9.0 Nm) tightening torque, for
tightening nuts to the terminal studs.
CAUTION: You must use an appropriate torque-controlled tool to tighten
the nuts. Applying excessive torque damages the terminal studs. The
maximum torque that may be applied to this nut is 99 lb-in. (11 Nm).
•
Phillips (+) screwdriver, number 2
•
DC power cables, which you must provide.
•
DC power lugs
Related
Documentation
PTX5000 Power System Description on page 37•
• Connecting DC Power to the PTX5000 Packet Transport Switch on page 94
93Copyright © 2012, Juniper Networks, Inc.
To Next Page
Loading...
