CHAPTER 4
PTX5000 Packet Transport Switch
Installation Summary
•
Overview of Installing the PTX5000 Packet Transport Switch on page 53
Overview of Installing the PTX5000 Packet Transport Switch
You must proceed through the installation process in the following order:
1. Prepare the installation site for the packet transport switch.
See “Overview of Preparing the Site for the PTX5000 Packet Transport Switch” on
page 55.
2. Review all safety guidelines and warnings for the packet transport switch.
WARNING: To avoid harm to yourself or the packet transport switch as
you install and maintain it, you must follow the safety procedures for
working with packet transport switches, as well as the guidelines and
warnings for working with and near electrical equipment. However,
providing an exhaustive set of guidelines for working with electrical
equipment is beyond the scope of this documentation.
See “PTX5000 Installation Safety Guidelines” on page 225.
3. Unpack the packet transport switch and verify the parts received.
See “Overview of Unpacking the PTX5000 Packet Transport Switch” on page 61.
4. Install the mounting hardware for your rack or cabinet.
•
See “Installing the PTX5000 Mounting Hardware for an Open-Frame Rack” on
page 71.
•
See “Installing the PTX5000 Mounting Hardware for a Four-Post Rack or Cabinet”
on page 67.
5. Install the packet transport switch using a mechanical lift.
See “Overview of Installing a PTX5000 Packet Transport Switch Using a Mechanical
Lift” on page 75.
53Copyright © 2012, Juniper Networks, Inc.
To Next Page
Loading...
