Juniper PTX Series - Replacing a Compactflash Card in a PTX5000 Routing Engine; Removing a Compactflash Card from a PTX5000 Routing Engine; Figure 81: Installing a Routing Engine

Figure 81: Installing a Routing Engine
DISK 2
DISK 1
Compact Flash
ATTENTION
Offline RE
before removing
cover.
Electrostatic
Sesitive
Device
g006165
DISK 2
DISK 1
Compact Flash
ATTENTION
Offline RE
before removing
cover.
Electrostatic
Sesitive
Device
Related
Documentation
PTX5000 Routing Engine Description on page 44•
• PTX5000 Routing Engine LEDs on page 47
• Troubleshooting the PTX5000 Routing Engines on page 145
• Preventing Electrostatic Discharge Damage to a PTX5000 Packet Transport Switch
on page 222
Replacing a CompactFlash Card in a PTX5000 Routing Engine
1.
Removing a CompactFlash Card From a PTX5000 Routing Engine on page 207
2.
Installing a CompactFlash Card in a PTX5000 Routing Engine on page 208
3.
Copying the Junos OS to the CompactFlash Card in a PTX5000 Routing
Engine on page 209
Removing a CompactFlash Card From a PTX5000 Routing Engine
The CompactFlash card is located in the slot labeled CompactFlash on the Routing Engine
faceplate. To remove the CompactFlash card:
1. Place an electrostatic bag or antistatic mat on a flat, stable surface.
2. Determine whether the host subsystem is functioning as the master or as the backup,
using one of these methods:
•
Check the MASTER LED on the control board. If the blue MASTER LED is lit, the host
subsystem is functioning as the master.
•
Issue the following CLI command. The master Routing Engine is designated Master
in the Current state field:
user@host> show chassis routing-engine
Routing Engine status:
Slot 0:
Current state Master
207Copyright © 2012, Juniper Networks, Inc.
Chapter 15: Replacing Packet Transport Switch Hardware Components