APPENDIX E
Packet Transport Switch Cable, Wire, and
Pinout Specifications and Guidelines
•
PTX5000 Network Cable Specifications and Guidelines on page 267
•
PTX5000 Management Interface Cable Specifications on page 271
•
RJ-45 Connector Pinouts for the PTX5000 Management HOST/ETHERNET
Port on page 272
•
RJ-45 Connector Pinouts for the PTX5000 AUXILIARY and CONSOLE Ports on page 272
•
PTX5000 Alarm Relay Contact Wire Specifications on page 273
PTX5000 Network Cable Specifications and Guidelines
•
Network Cable and Transceiver Overview for PTX Series Packet Transport
Switches on page 267
•
Understanding Fiber-Optic Cable Signal Loss, Attenuation, and Dispersion on page 268
•
Calculating Power Budget and Power Margin for Fiber-Optic Cables on page 269
Network Cable and Transceiver Overview for PTX Series Packet Transport Switches
PTX Series Packet Transport Switches support a variety of fixed and pluggable
transceivers and network cable, including multimode and single-mode fiber-optic cable.
For a list of transceivers, see
http://www.juniper.net/techpubs/en_US/release-independent/junos/topics/reference/general/transceiver-m-mx-t-series-standards-by-model.html.
To determine which transceivers and cables are supported on a particular device, see
the “Cables and connectors” section for each PIC in the PTX5000 Packet Transport Switch
PIC Guide.
For transceiver and cable specifications, see:
•
10-Gigabit Ethernet 10GBASE Optical Interface Specifications
•
40-Gigabit Ethernet 40GBASE Optical Interface Specifications
•
100-Gigabit Ethernet 100GBASE Optical Interface Specifications
Related
Documentation
Calculating Power Budget and Power Margin for Fiber-Optic Cables on page 269•
• Understanding Fiber-Optic Cable Signal Loss, Attenuation, and Dispersion on page 268
267Copyright © 2012, Juniper Networks, Inc.
To Next Page
Loading...
