RJ-45 Connector Pinouts for the PTX5000 Management HOST/ETHERNET Port
The management Ethernet port on the control board labeled HOST/ETHERNET is an
autosensing 10/100-Mbps/1-Gbps Ethernet RJ-45 receptacle that accepts an Ethernet
cable for connecting the Routing Engine to a management LAN (or other device that
supports out-of-band management). Table 52 on page 272 describes the RJ-45 connector
pinouts.
Table 52: RJ-45 Connector Pinouts
SignalPin
TX+1
TX –2
RX+3
Termination network4
Termination network5
RX–6
Termination network7
Termination network8
Related
Documentation
PTX5000 Control Board Description on page 22•
• Connecting the PTX5000 Packet Transport Switch to a Management Ethernet Device
on page 90
RJ-45 Connector Pinouts for the PTX5000 AUXILIARY and CONSOLE Ports
The ports on the control board labeled AUXILIARY and CONSOLE are RJ-45 receptacles
that accept RS-232 (EIA-232) cable. The AUXILIARY port connects the Routing Engine
to a laptop, modem, or other auxiliary unit, and the CONSOLE port connects it to a
management console. The ports are configured as data terminal equipment (DTE). Table
53 on page 272 describes the RJ-45 connector pinouts.
Table 53: RJ-45 Connector Pinouts for the PTX5000 AUXILIARY and
CONSOLE Ports
DescriptionDirectionSignalPin
Carrier Detect<–DCD1
Receive Data<–RxD2
Copyright © 2012, Juniper Networks, Inc.272
PTX5000 Packet Transport Switch Hardware Guide
To Next Page
Loading...
