6. Locate the slot in the FPC card cage in which you plan to install the FPC.
7. Inspect the slot in the FPC card cage to verify that there are no missing or bent pins
on the midplane.
8. Inspect the FPC to verify that the connectors are not misaligned or damaged.
9. Orient the FPC vertically with the component side facing to the right. Be sure the FPC
is right-side up, with the components on the right of the FPC.
CAUTION: When the FPC is out of the chassis, do not hold it by the ejector
handles, bus bars, or edge connectors. They cannot support its weight.
10. Carefully align the connector edge of the FPC with the appropriate empty slot in the
chassis.
11. Lift the FPC into place and carefully align the bottom and top of the FPC with the
guides inside the card cage.
Figure 61: Installing an FPC
g006195
FPC-PTX
P1-A
P1-PTX
24-10GE-SFPP
STATUS
ONLINE
0
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
TX
TX
RX
RX
23
OFFLINE
P1-PTX
24-10GE-SFPP
STATUS
ONLINE
0
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
TX
TX
RX
RX
23
OFFLINE
12. Gently rest the bottom edge of the FPC on the bottom edge of the slot opening, making
contact a short distance forward of the power connector.
Copyright © 2012, Juniper Networks, Inc.176
PTX5000 Packet Transport Switch Hardware Guide
To Next Page
Loading...
