Juniper PTX Series - PTX5000 General Laser Safety Guidelines; Laser Safety Warnings for M Series, MX Series, and T Series Routers, and PTX Series Packet Transport Switches; Class 1 Laser Product Warning

PTX5000 General Laser Safety Guidelines
Devices with single-mode optical interfaces are equipped with laser transmitters, which
are considered a Class 1 Laser Product by the U.S. Food and Drug Administration, and
are evaluated as a Class 1 Laser Product per EN 60825–1 +A11 +A2 requirements.
When working around devices with optical interfaces, observe the following safety
guidelines to prevent eye injury:
•
Do not look into unterminated ports or at fibers that connect to unknown sources.
•
Do not examine unterminated optical ports with optical instruments.
•
Avoid direct exposure to the beam.
WARNING: Unterminated optical connectors can emit invisible laser
radiation. The lens in the human eye focuses all the laser power on the
retina, so focusing the eye directly on a laser source—even a low-power
laser—could permanently damage the eye.
Related
Documentation
PTX Series PIC Description on page 36•
• Connecting PIC Cables to the PTX5000 Packet Transport Switch on page 87
• Maintaining the PTX5000 PIC Cables on page 112
• Replacing a PTX5000 PIC on page 178
• Replacing a PTX5000 PIC Cable on page 181
• Laser Safety Warnings for M Series, MX Series, and T Series Routers, and PTX Series
Packet Transport Switches on page 231
Laser Safety Warnings for M Series, MX Series, and T Series Routers, and PTX Series Packet
Transport Switches
•
Class 1 Laser Product Warning on page 231
•
Class 1 LED Product Warning on page 232
•
Laser Beam Warning on page 232
•
Radiation from Open Port Apertures Warning on page 233
Class 1 Laser Product Warning
WARNING: Class 1 laser product.
Waarschuwing Klasse-1 laser produkt.
Varoitus Luokan 1 lasertuote.
Attention Produit laser de classe I.
231Copyright © 2012, Juniper Networks, Inc.
Appendix A: PTX5000 Safety and Regulatory Compliance Information