Juniper PTX Series - Figure 69: Removing the Vertical Fan Tray; Installing a PTX5000 Vertical Fan Tray

Figure 69: Removing the Vertical Fan Tray
g006170
FANTRAY
PTX
VERTICAL
Installing a PTX5000 Vertical Fan Tray
To install a replacement vertical fan tray (see Figure 70 on page 194):
1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
the strap to one of the ESD points on the chassis.
2. Grasp the fan tray handle and insert it straight into the chassis.
3. Tighten the captive screw on the bottom of the fan tray faceplate to secure it in the
chassis, using a Phillips (+) screwdriver, number 2.
193Copyright © 2012, Juniper Networks, Inc.
Chapter 15: Replacing Packet Transport Switch Hardware Components