Juniper PTX Series - Removing the Center-Mounting Brackets; Figure 32: Installing the Mounting Hardware for a Four-Post Rack

Figure 32: Installing the Mounting Hardware for a Four-Post Rack
g006189
2
1
2—1— Four-post mounting shelfRear support bracket
Removing the Center-Mounting Brackets
The center-mounting brackets are not used for a four-post rack, and must be removed
from the chassis.
To remove the center-mounting brackets from the chassis:
1. Loosen the screws from each bracket (see Figure 33 on page 71).
2. Remove each bracket.
Copyright © 2012, Juniper Networks, Inc.70
PTX5000 Packet Transport Switch Hardware Guide