Juniper PTX Series - Index

Index
Symbols
#, comments in configuration statements.................xxiii
( ), in syntax descriptions..................................................xxiii
< >, in syntax descriptions.................................................xxiii
[ ], in configuration statements......................................xxiii
{ }, in configuration statements......................................xxiii
| (pipe), in syntax descriptions........................................xxiii
A
agency approvals.................................................................249
alarm
messages.........................................................................119
alarms
handling by Routing Engine.......................................44
LEDs (red and yellow) on craft interface..............29
mode for LCD display....................................................27
altitude, acceptable range................................................257
analyzer, use of........................................................................112
antistatic mat, using............................................................222
approvals, agency................................................................249
architecture
Packet Forwarding Engines...........................................7
ASICs
Lookup ASIC........................................................................7
Queuing and Memory Interface ASIC........................7
attenuation in fiber-optic cable.....................................268
auxiliary port.............................................................................22
auxiliary port (for Routing Engine management)
cable
connection during initial installation.............86
cable connector pinouts (RJ-45)...........................272
B
battery
environmental compliance......................................253
lithium..............................................................................253
braces, in configuration statements..............................xxiii
brackets
angle, in syntax descriptions...................................xxiii
square, in configuration statements.....................xxiii
C
cable
auxiliary or console port (for Routing Engine
management)
connecting during initial installation.............86
PIC
maintaining.............................................................112
cable management system
fiber-optic cable, use with..........................................112
cables
fiber-optic
attenuation...........................................................268
dispersion..............................................................268
multimode and single-mode.........................268
transmission distance, maximum...............268
wavelength ranges............................................268
case number, for JTAC.........................................................275
chassis..........................................................................................12
alarm messages See alarm, messages
ESD points.........................................................................12
grounding points..............................................................12
weight..............................................................................255
chromatic dispersion in fiber-optic cable...................268
CLI
as troubleshooting tool...............................................117
command
to display chassis alarm messages...............119
to display FPC status............................................111
to display PIC status............................................112
to display serial number...................................278
commands
ping......................................................................................117
show chassis alarms....................................................119
show chassis fpc
for FPC status..........................................................111
show chassis fpc pic-status......................................112
show chassis hardware.............................................278
traceroute..........................................................................117
comments, in configuration statements.....................xxiii
compatibility, electromagnetic.......................................245
compliance
EMC requirements.............................................250, 251
general standards.......................................................249
components
chassis.................................................................................12
cooling system.................................................................18
field replacement.........................................................156
FPCs....................................................................................32
midplane............................................................................14
291Copyright © 2012, Juniper Networks, Inc.