NOTE: You may get an error message and be prompted for a keystroke.
After you press the keystroke, it might takeup to 10 minutes for the Routing
Engine to reset and for the router to boot from the solid-state disk.
Copying the Junos OS to the CompactFlash Card in a PTX5000 Routing Engine
After installing the CompactFlash card for the first time, you must copy the software
from the Routing Engine's solid-state disk to the CompactFlash card.
NOTE: For more information about the commands for this procedure, see
the Junos OS System Basics and Services Command Reference
To copy software to the CompactFlash card:
1. On the console or other management device connected to the Routing Engine, enter
CLI operational mode and issue the request system snapshot partition command to
copy the currently running and active file system partitions on the router to standby
partitions on the CompactFlash card.
2. Wait until a message appears on the console confirming that the snapshot partition
procedure is complete.
3. Issue the request system reboot command to reboot the router's software. The
CompactFlash card will now be the primary boot device.
4. Issue the show system boot-messages command to verify that boot order is correct.
The output lists the devices mounted. The CompactFlash card is located at ad0.
Related
Documentation
PTX5000 Routing Engine Description on page 44•
• PTX5000 Routing Engine LEDs on page 47
• Troubleshooting the PTX5000 Routing Engines on page 145
• Preventing Electrostatic Discharge Damage to a PTX5000 Packet Transport Switch
on page 222
Replacing a Solid-State Disk in a PTX5000 Routing Engine
1.
Removing a Solid-State Disk From a PTX5000 Routing Engine on page 210
2.
Installing a Solid-State Disk in a PTX5000 Routing Engine on page 211
3.
Copying the Junos OS to the Solid-State Disk in a PTX5000 Routing Engine on page 211
209Copyright © 2012, Juniper Networks, Inc.
Chapter 15: Replacing Packet Transport Switch Hardware Components
To Next Page
Loading...
