Juniper PTX Series - FPC Terminology; Identifying the Fpcs; Figure 18: FPC Edges

•
Two LEDs on the FPC that display the status of the FPC
•
FPC online/offline button
FPC Terminology
Regardless of whether you are holding an FPC vertically or horizontally, this document
uses the same terms for all four edges of the FPC (see Figure 18 on page 33):
•
Faceplate—Edge of the FPC that has slots into which you insert the PICs
•
Connector edge—Edge opposite the faceplate; this edge has the connectors that attach
to the midplane
•
Top edge—Edge at the top of the FPC when it is vertical
•
Bottom edge—Edge at the bottom of the FPC when it is vertical
Figure 18: FPC Edges
Identifying the FPCs
Check the label on the faceplate to identify the FPC.
33Copyright © 2012, Juniper Networks, Inc.
Chapter 3: PTX5000 Hardware Components Overview