Juniper PTX Series - Figure 50: Removing a Routing Engine from a Control Board; Figure 51: Removing a Control Board; Installing a PTX5000 Control Board

Figure 50: Removing a Routing Engine from a Control Board
DISK 2
DISK 1
Compact Flash
ATTENTION
Offline RE
before removing
cover.
Electrostatic
Sesitive
Device
g006164
DISK 2
DISK 1
Compact Flash
ATTENTION
Offline RE
before removing
cover.
Electrostatic
Sesitive
Device
Figure 51: Removing a Control Board
g006162
DISK 2
DISK 1
Compact Flash
ATTENTION
Offline RE
before removing
cover.
Electrostatic
Sesitive
Device
Installing a PTX5000 Control Board
To install a control board (see Figure 52 on page 165):
1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
the strap to an approved site ESD grounding point.
2. Carefully align the bottom and then the top edges of the control board with the guides
inside the chassis.
3. Slide the control board into the chassis, carefully ensuring that it is correctly aligned.
4. Twist both ejector handles clockwise to seat the host subsystem until the ejectors
latch into the faceplate.
5. Install the Routing Engine into the control board.
Copyright © 2012, Juniper Networks, Inc.164
PTX5000 Packet Transport Switch Hardware Guide