Juniper PTX Series - PTX5000 Craft Interface Description; Craft Interface Front Panel; Figure 14: Craft Interface

PTX5000 Craft Interface Description
The craft interface allows you to view status and troubleshooting information at a glance
and to perform many system control functions. It is hot-insertable and hot-removable.
The craft interface is located at the upper front of the PTX5000 Packet Transport Switch.
•
Craft Interface Front Panel on page 26
•
Craft Interface LCD on page 27
•
LCD Navigation Buttons on page 28
Craft Interface Front Panel
Figure 14 on page 26 shows the craft interface.
Figure 14: Craft Interface
1
2
g006126
1 2 3 4
5
8 9 107
6
6—1— Alarm LEDs and ACO/LT buttonAlarm relay contacts
7—2—
M/S CHASSIS NUM configuration
switches
SIB LEDs
8—3— Power system LEDsHost Subsystem LEDs
9—4— LCDCCG LEDs
10—5— LCD navigation buttonsFan tray LEDs
The front panel of the craft interface contains:
•
A four-line LCD display, along with six navigation buttons. The LCD display operates
in Idle mode or alarm mode.
•
Alarm relay contacts.
•
Two configuration switches:
•
The M/S configuration switch must be set to S.
•
The CHASSIS ID configuration switch must always be set to 0.
NOTE: The CHASSIS ID configuration switch is set to 0 by default.
•
LEDs
Copyright © 2012, Juniper Networks, Inc.26
PTX5000 Packet Transport Switch Hardware Guide