5- 6 Keysight B2961A/B2962A SCPI Command Reference, Edition 6
Error Messages
Command Error
Error -131 Invalid suffix
The suffix does not follow the correct syntax or the suffix is inappropriate.
Error -134 Suffix too long
The suffix contains more than 12 characters.
Error -138 Suffix not allowed
A suffix was received after a numeric parameter that does not allow suffixes.
Error -140 Character data error
An error was detected in a character parameter. This error message is reported if
B2961A/B2962A cannot determine the more specific errors -141 through -148.
Error -141 Invalid character data
Either the character parameter contains an invalid character or the particular element
received is not valid for the command header.
Error -144 Character data too long
The character parameter contains more than 12 characters.
Error -148 Character data not allowed
A character parameter is not allowed for this position.
Error -150 String data error
An error was detected in a string parameter. This error is reported if
B2961A/B2962A cannot determine a more specific error -151 and -158.
Error -151 Invalid string data
An invalid string parameter data was received; for example, an END message was
received before the terminal quote character.
Error -158 String data not allowed
A string parameter data was received but was not allowed at this point.
Error -160 Block data error
An error was detected in a block data. This error is reported if B2961A/B2962A
cannot determine more specific errors -161 and -168.
To Next Page
Loading...
Need help?
General
