Keysight Technologies B2961A - Page 74

2- 34 Keysight B2961A/B2962A SCPI Command Reference, Edition 6
Subsystem Command Summary
Setting Source Output and Measurement
:OUTP[c]:OFF:AUTO mode
:OUTP[c]:OFF:AUTO?
Enables or disables the automatic output
off function.
mode=1|ON|0|OFF
OFF
:OUTP[c]:OFF:MODE mode
:OUTP[c]:OFF:MODE?
Selects the source condition after output
off.
mode=ZERO|HIZ|NORMal
NORM
:OUTP[c]:ON:AUTO mode
:OUTP[c]:ON:AUTO?
Enables or disables the automatic output
on function.
mode=1|ON|0|OFF
ON
:OUTP[c]:PROT[:STAT] mode
:OUTP[c]:PROT[:STAT]?
Enables or disables the over voltage/
current protection.
mode=1|ON|0|OFF
OFF
:OUTP[c]:REC index
Recalls the channel setup.
index=0 or 1 to recall the channel setup 0
or 1 saved by the :OUTP:SAVE
command.
:OUTP[c]:RES:EMUL:CURR list1
:OUTP[c]:RES:EMUL:CURR?
:OUTP[c]:RES:EMUL:VOLT list2
:OUTP[c]:RES:EMUL:VOLT?
:OUTP[c]:RES:EMUL:MODE list
:OUTP[c]:RES:EMUL:MODE?
Sets the current list, voltage list, or source
type list used for the emulation mode
operation of the programmable output
resistance function. Each data must be
separated by a comma.
list1: Output current list. list1 must
contain 2 to 16 data. Number of data must
be the number of data in the source type
list plus 1.
list2: Output voltage list. list2 must
contain 2 to 16 data. Number of data must
be the number of data in the source type
list plus 1.
list: Source type list. list must contain 1 to
15 data.
-1e-4,1e-4
for CURR
0.0,0.0 for
VOLT
VOLT for
MODE
Command Summary Reset setting