128 Keysight N9038A MXE Service Guide
Instrument Messages
Condition Messages
705 2 unused
707 3 Sweeping status bit
only
709 4 Measuring status bit
only
711 5 Waiting for Trigger status bit
only
713 6 Waiting for Arm status bit
only
715 7 unused
717 8 Paused status bit
only
719 9 Source Sweeping status bit
only
The “Source Sweeping” bit is used to indicate
various conditions, depending on the Mode of
operation:
In the List Sequencer mode, it is used to indicate
that the sequencer is running
In the EMI Receiver mode, it is used to indicate
that scan results are available from the Frequency
Scan measurement
721 10 DC Coupled W
723 11 unused
725 12 Source Waiting for
Trigger
status bit
only
727 13 unused
729 14 unused
Err# Bit in
status
register
Message Error or
Warning
More Information
To Next Page
Loading...
Need help?
General
