530 Keysight N9038A MXE Service Guide
Assembly Replacement Procedures
Tools you will need
Tools you will need
Figure 18-1 TORX Tool
Adjustments Tests after an instrument repair
Refer to Chapter 19, “Post-Repair Procedures” for information about
post-repair procedures. If one or more instrument assemblies have been
repaired or replaced, perform the related adjustments and performance
verification tests.
Hand Tool Size
Cable Puller (5021-6773)
Nut Driver 3/16 inch
Nut Driver 5/16 inch
Nut Driver 9/16 inch
Open-End Wrench 5/16 inch
Torque Driver - Adjustable Multi Bit
Torque Wrench - 10 inch-lbs 5/16 inch
TORX Driver T-8
TORX Driver T-10
TORX Driver T-20
To Next Page
Loading...
Need help?
General
