Keysight N9038A MXE Service Guide 31
Overview
After an Instrument Repair
After an Instrument Repair
If any instrument assemblies have been repaired or replaced, perform the
related adjustments and performance verification tests. Most of these tests are
done using the N7818A Keysight MXE EMI Receiver Calibration Application
Software. Refer to Chapter 19, “Post-Repair Procedures” for a list of
post-repair adjustments and performance tests based on which hardware has
been changed.
Information regarding the N7818A Keysight MXE EMI Receiver Calibration
Application Software can be found at
http://www.keysight.com/find/calibrationsoftware
Contacting Keysight Technologies
If you have a problem with your instrument, see Chapter 2, “Boot Up and
Initialization”. This section contains a checklist that will help identify some of
the most common problems.
There is also support on the world-wide web. The address is:
http://www.keysight.com/find/mxe_support
FAQs, instrument software updates, documentation, and other support
information can be accessed from this site.
To obtain servicing information or to order replacement parts, contact the
nearest Keysight office listed in Table 1-1. In any correspondence or telephone
conversations, refer to the instrument by its model number (N9038A) and full
serial number (ex. MY49250887). With this information, the Keysight
representative can quickly determine whether your unit is still within its
warranty period.
By internet, phone, or fax, get assistance with all your test and measurement
needs.
To Next Page
Loading...
Need help?
General
