592 Keysight N9038A MXE Service Guide
Assembly Replacement Procedures
Rear Panel
Replacement
1. Reattach the W21 cable to the rear panel. Torque to 21 inch-pounds using
the 9/16-inch nut driver.
2. If present, reattach W9 (5) from the rear panel. Torque to 9 inch-pounds
using the 3/16” nut driver.
3. If present, reattach W22 (3) from the rear panel. Torque to
10 inch-pounds using the 5/16” nut driver.
4. Place the rear panel into position in the chassis. Replace the sixteen
screws (0515-0372) to attach the rear panel to the chassis. Torque to
9 inch-pounds.
5. Replace the instrument outer case. Refer to the Instrument Outer Case
replacement procedure.
To Next Page
Loading...
