Keysight N9038A MXE Service Guide 599
Assembly Replacement Procedures
Disk Drive
5. Remove the disk drive (2) from the carrier assembly.
6. Place the new disk drive onto the carrier assembly and attach with the 4
machine screws (1) (0515-0372). Torque to 9 in-pounds.
7. Refer to Figure 18-50. Replace the disk drive carrier assembly (2) into the
instrument and tighten the screw to 9 in-pounds.
8. Refer to Chapter 19, “Post-Repair Procedures” and perform all of the
specified tasks for replacing the A5 Disk Drive assembly.
To Next Page
Loading...
